![]() Make a couple of cuts into the seam allowance on the neckline of the cape and then continue to pin the collar around the neckline, making sure that there is an equal distance of 3.5cm of the neckline edge extending from where the collar ends finish. Find the centre of the collar on the neck edge and match this to the centre back seam and pin in place. Tease out the corners and press.Īttach the collar to the neckline. Trim away the bulk from the tips and turn to the right side. With the right sides facing, pin and then stitch around the outer edges of the material and lining, with a 1cm seam allowance. Iron interfacing onto the back of the fabric. ![]() ![]() Repeat this process on the lining pieces, leaving a gap in the centre of the seam of approximately 15cm. Stitch the centre back seams of the cape together with a 1cm seam allowance. If you would like a stand up collar, cut out a strip measuring 45cm x 6cm, following the same cutting instructions. If the fabric is 150cm wide, each pair can be cut together, or if the fabric is narrower, cut the single piece out and then turn it over onto another piece of fabric to make a pair. Use this pattern to cut out the four pieces needed for the cape, following the cutting guide. Transfer the cape pattern pieces onto the half circle and mark on the centre back seam and the neckline. Unfold the paper and a half circle will have been formed (see diagram). Carry on marking the 70cm length from this point and an arc should appear. From this centre point, measure 70cm and mark. From one edge of the fold line, measure along 70cm and mark this point with a pencil. Fold a piece of paper measuring approximately 150cm x 75cm in half lengthways.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |